Septic Tank Cleaning Service-The Inside Story

Class 4 septic systems are divided into two components, the septic tank and the septic field or leaching bed. Waste is piped out of the house into the septic tank, which is essentially a water clarification tank, in which anaerobic bacteria break the waste down into solids (sludge), liquid effluent, and scum.The solids settle to the bottom, the scum floats to the top and the liquid effluent flows through an outlet pipe into a distribution chamber, where it is directed to the septic field. The septic field is an effluent water disposal system, where the liquid is channeled through perforated pipes to different parts of a field of loose gravel.Materials that initially float in the scum layer are kept out of the drainage sytem by an outflow tee or baffle. If the tank is not pumped regularly, the level of solids can rise, and if it approaches the level of the outflow tee, scum and solids can proceed out into the drainage system, clogging the pipes and gravel – and eventually preventing the absorption of the water by the surrounding earth.Click to Read more about septic tank cleaning service Your Satisfaction Guaranteed.

A Class 5 septic system is a holding tank for the storage of sewage at the site where it is produced. A typical holding tank system is comprised of a single compartment tank with a pump-out stack and an audible or visual warning device to alert the homeowner when the tank requires emptying. A holding tank is costly to operate, places restrictions of the owner, and is dependent on Class 7 (hauled) sewage system for waste collection and disposal.A property serviced by a holding tank system requires an agreement registered on title to notify current and future owners of the servicing restrictions on the property.With proper septic tank maintenance and care, your septic tank and field should provide many years of trouble-free service. There are, however, some important steps to follow to help you maintain the proper operation of your sewage disposal system.

The septic tank in a residential system should be inspected at least once every two years for sludge buildup. The tank should be pumped by a licensed septic tank pumping contractor when necessary. Under normal use a septic tank should have its contents removed every two to three years.The use of starters, bacterial feeds or cleaners in a septic system is normally not necessary.The final grade (top soil) over the field should not be altered after it has been installed and inspected, and should be kept grassed after installation. Shrubs, trees or gardens should not be established over the septic field.Discharge from evestough drains and sump pumps should not be directed into or over a septic field, and lawn sprinkler systems must not be located within this area.

Limiting excessive amounts of water in a short time can help reduce disruption of the septic process. You may want to consider the following water use reduction practices:The use of biodegradable products is highly recommended. Disposal of non-biodegradeable products such as condoms, feminine hygiene products, plastics, dental floss, etc. is strongly discouraged.If you have questions regarding the care and maintenance of your septic system, consult your contractor or the Environmental Protection Division of your local Health Department.The standards for private sewage systems are prescribed in Ontario Regulation 358/90, under the Enviromental Protection Act, and the Guidelines established by Ministry of Environment, and requirements of your local munipality or township.

If there is no record of the system having been pumped but the owner has a vague recollection of pumping the system at some time in the distant past, figure that it has never been pumped.If the system is over 10 years old and has never been pumped, it is possible that there has been some damage to the septic field, and if it’s not been pumped for over 15 years it is quite likely.The only way to make an accurate determination of the system is to have a licensed contractor or engineering firm perform a tank, distribution chamber and field inspection, and possibly soils sampling.Flushing dye through the system looks good but will only indicate systems that are already seriously clogged, in which case there should already be more obvious signs.Flushing dye may not indicate serious defects or indicate systems that are close to failure but still functional.